IBM DS3200 Manuale Utente Scaricare il pdf (Pagina 114)

The following illustration shows a drive compatibility key.

To replace a drive compatibility key, complete the following steps:

1. Read the safety information that begins on page xi and “Best practices

guidelines” on page 6.

2. Turn off the DS3200, or wait until the DS3200 is shut down for maintenance.

3. Remove the three hard disk drives that are in the column of bays that contain

the broken drive compatibility key. See “Removing a hard disk drive” on page

74.

4. Remove the broken drive compatibility key:

a. Flex the rear of the key slightly toward the middle of the bay to release it

from the tab that holds it.

b. Slide the key toward the front of the bay until it is released from the chassis.

5. Install the replacement drive compatibility key:

a. Orient the key as shown in the illustration.

b. Place the key between the drive guides in the left wall of the bay, flush with

the wall.

c. Slide the key tab under the metal tab that is on the left wall of the bay; then,

slide the key toward the rear of the chassis until the key stops (the key is

Tab

Figure 60. Drive compatibility key

System

torage

Key tab

Bay tab

Guides

Correct key tab

position

Figure 61. Installing a drive compatibility key

96 System Storage DS3200 Storage Subsystem: Installation, User’s, and Maintenance Guide

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 143 144

Nessun commento

IBM DS3200 Manuale Utente Pagina 114